: giltex58 - Viewing Profile

I have used them for several years firing 5-6. Not sure why they are not working for you especially the PC 20. Go back to the web site and read instructions carefully again; you might have an application problem. I usually thin down my jars with a little water, some of the glazes are really thick. Now Antique Jasper...this one is often tough to get right. I put it on really thick at least 3 coats after previous coat is dry then I "splotch" over the third coat using a thick brush and dabbing the glaze in no set pattern. Here is a recent Antique Jasper:  P1000470.JPG (224.84K)
Number of downloads: 50

I started out signing on bottoms the name of my pottery. Then I got fussed at. A lot of my former students said they wanted a piece that I made and signed with my name. Since I have hundreds of former students in the county I couldn't pass this up. I sign taylor on the bottom with a needle tool in a type of scripted print and lower case and sometimes the year date for a special piece. I kid with customers and tell them "Look at the bottom, it doesn't say Made in C...."

Do you have a Radio Shack nearby? Pic looks like a half shaft that will take a knob that has a set screw in it. If no markings on a knob paint a line or arrow on it.

Since I'm still a young potter (7 years) and didn't know any better I started out hanging my business card , or dropping it in the pot, on everything I display for sale. I have pots in 3 gift stores and everyone really likes the colorful business card attached. I put the price on the back of the card. Just got in 500 more cards from Vistaprint for $12.47. I cut pieces of curly Christmas ribbon to hang the cards with. That's a pain cause my fingers are so big. Just an idea though.

Great idea, going to make me one, but what did you use to face the block side that touches the pot?