dee kat's Profile
Reputation: 1 Neutral
- Active Posts:
- 4(0 per day)
- Most Active In:
- Clay and Glaze Technical (3 posts)
- 06-April 10
- Profile Views:
- Last Active:
- Oct 01 2012 12:41 PM
Posts I've Made
Posted 1 Oct 2012OK, so I am finally moving to a place where I have space for a kiln - YAY! But I do not have a kiln and can not afford to buy one. What is the least expensive way to build a kiln? Any help greatly appreciated!
Making a gas kiln I would think would be easier than an electric but much harder to fire. Simon Leach has taken an old electric kiln and turned it into a gas kiln (propane). You can usually find old electric shells that people want to get rid of because the controller has died.
If you do go the route of rebuilding an electric kiln then you are going to have to control the temperature. For the old kilns before computer controllers that was done by turning different numbers of elements on to either low, medium or high heat. So you would start out turning the bottom element on to low for a given time - for greenware you would often candle overnight so this would be on low with the lid propped open an inch or so. The next morning the lid would close and you would turn the second element on to low and run like that for an hour then the top would be turned on to low. Each hour would turn one switch up one level of heat until all were on high for all three elements. You would have a shut off switch that was kept open with a cone of the temperature you wanted to fire to and when that cone bent the setter would fall and the switch would flip to turn the kiln off. There would be a timer that turned the kiln off after a maximum number of hours as a safety measure. Any sane potter would know the timing of the firing and would check at regular intervals to make sure the kiln had not shutdown prematurely or failed to shut off when it should (so there were always witness cones on the shelves that you could look at the check your firing heat work (something close to temperature but not really).
So other than the shell you are going to need 3 sets of electric coils that will fit your kiln and a means of turning them on and off. You will need cones for monitoring your temperature. If you are going to do ramping or soaking then you are going to need to learn more than just turning on the elements and firing at high until you reach temperature. There are many posts on doing this with an electric kiln without a computer controller but you will need a pyrometer.
Youtube is good for this type of information. Somewhere I have the one on rebuilding an electric kiln but I can't find it at this time.
- Member Title:
- Age Unknown
- Birthday Unknown
dee kat hasn't added any friends yet.