Extraction For Spraying Glaze
Posted 04 April 2010 - 07:35 AM
Posted 04 April 2010 - 02:10 PM
Attached please find an Autocad Drawing with the details of a dry DIY spray booth. To open the ACAD drawing download the free Autodesk program "dwg true view 2010", that will allow you to see and print the drawing.
I can send you a plan for a wet spray booth where a water curtain cleans and retains the excess spray. but it is more complicated. If you abble with your hands, let me know and I will make a sketch of the other one. Feel free to give this design to anybody interested.
Best Regards. Eduardo
P.S. Refusal of attaching a dwg drawing. Replaced it with a jpeg copy. Very unclear. If you cannot read it please let me know and i will send it by email.
Number of downloads: 116
Posted 05 April 2010 - 10:47 AM
I have made two spraybooths recently and have a very good source for a simple extraction fan. Find a Sheetmetal company in your area and locate their shop. Find a large company if you can because they will have more fans available. They are regularily doing changes to office HVAC systems that requires replacing old fans. These fans come in many sizes and come boxed in and ready to attach to whatever you are using for your booth. I used a cardboard box for my first booth with a fan that measured about 12" x 12" These are a squirrel-cage type fan and are very efficient. The company I go to throws the old fans away and they work just great. I find them sitting out by their garbage area and a visit to the shop office usually gets an enthusiastic offer to help myself. All that is needed after that is a cheap furnace filter from your local hardware store and you are in buisiness.
My new booth I actually had the same sheetmetal company build me the booth and it was quite cheap. They used 24 gauge galvanized and it was about about 30'x30"x30" open on one side. Then I waited until the right fan came along cut the hole to suit the fan and I was good to go.
Posted 06 April 2010 - 11:48 AM
Posted 06 April 2010 - 11:54 AM
Posted 09 July 2010 - 06:12 PM
There are lots of good suggestions. When I was in school ages ago, one suggestion was find a used dryer with the heating elements burnt out and still has the exhaust in tact. Gut what you can, cut off the front and the fan/vent should be in the back. Clean up sharp edges. The blower should run on 120V.