Leveling the Wheel How many of you take time to use a level on the wheel?
Posted 27 March 2012 - 05:05 PM
Posted 27 March 2012 - 05:52 PM
After moving my wheel, I started to notice that the foot ring on my bowls was not the same height all around. My husband suggested checking the level. It was only out about 1/4 inch but once corrected, my foot rings were even again.
Posted 27 March 2012 - 08:43 PM
Kiln Repair Tech
Owner, Neil Estrick Gallery, LLC
Posted 27 March 2012 - 09:19 PM
I too have worked on a wheel that was not level. It drove me crazy. It was, as has been mentioned, the foot ring problem that made me nuts!!! Everyone said "just shim the leg." While shimming would be okay for once in a while you really need a level to ensure it is correct.
In my new studio, I insisted in the pouring of the concrete that the floor was level. I actually made a big deal about it. Last week, my contractor had his big level out and we checked my wheel head and lo and behold it was perfect. The bubble was in the center of the guage.
I think part of my decision to get a Soldner wheel was based on the fact you can adjust the feet. When and if I move my clay studio, at least I will have these feet ready to make the throwing and trimming surface level.
I do think, testing the level of your wheel from time to time is good studio practice. It can prevent a melt down when you repeatedly throw pieces you think are solid only to have them ruined by an uneven foot ring.
Posted 28 March 2012 - 09:32 AM
Too many great answers here to name all of you. Some of you know that I moved my studio over Christmas. I hurt my back. Been going to physio for two months. It turns out that my right leg is longer than my left by half an inch. I noticed that when I write on the board, it always slants up toward the right. So, the question is;If I am not level, how can I expect my wheel to be level?
You don't need to answer.